Removing the water lter
The water lter should not be left standing dry for a long period of time.
When it is not used for a long time, we recommend storing the water lter
in a vessel lled with tap water in the refrigerator.
Remove the water lter as follows:
Requirement: The ready symbol appears on the display.
1. Press the "menu/ok" button for longer than 2 seconds.
» The menu appears on the display.
2. Navigate to the Care > Filter > Remove lter menu.
3. Select Start using the arrow buttons and conrm with "menu/ok".
4. Follow the further instructions on the display.
» The water hardness is automatically reset to the previous setting.
» The ready symbol appears on the display.
5. Re-adjust the water hardness if necessary, (see section 9.8 Setting the
water hardness on page87).
10 Problems
If the actions listed below fail to rectify the problems or other problems not
listed here occur, contact our hotline (local rate).
Germany: +49 571/ 861 900
Austria: +43 810/ 100 500
Switzerland: +41 62/ 388 98 48
Luxemburg: +32 9/ 331 52 30
Problem Cause Action
Coee only emerges
in drips from the
outlet.
Grinding neness
too ne.
Set a coarser grinding neness (see
section 8.7 one page81).
Appliance soiled. Clean the brewing unit (see sec-
tion9.3 one page83).
Run the cleaning programme (see
section9.6 one page86).
Appliance is covered
inside with limescale.
Descale the appliance (see sec-
tion 9.7 one page86).
Coee does not ow. Water tank not lled
or inserted incor-
rectly.
Fill the water tank and ensure it is
positioned correctly (see sec-
tion4.5 one page64).
Brewing unit
clogged.
Clean the brewing unit (see sec-
tion 9.3 one page83).
To Next Page
Loading...
Need help?
General
