1-833-454-0864
12
MATCH LIGHTING THE MAIN BURNER:
1. Open lid before lighting burner.
2. Make sure all control knobs and LP Cylinder shut-o valve are “OFF”.
3. SLOWLY, turn the LP cylinder shut-o valve counter clockwise to open.
Wait 30 seconds for pressure to stabilize.
4. Place a paper match in the end of the match lighting tool. Strike match
and place through the cooking grate and opening on the heat tent
approximately 1/2” (1 to 2 cm) from the burner to be lit.
5. Push in and turn burner control knob to “HI” position . The burner
should light within 5 seconds.
6. If burner does not light, turn control knob to “OFF” and wait 5 minutes
for gas to dissipate and repeat lighting procedure.
7. Once lit, light adjacent burners by following steps 3-6.
8. If burner does not light within rst few attempts of match lighting, there is a problem with the gas supply.
Turn o gas at burner and cylinder. DO NOT attempt to operate grill until the problem is found and
corrected.
NOTE: If burner does not light or ame is too low, See “Troubleshooting” section of the owners manual.
LIGHTING THE SIDE BURNER:
1. Open lid before lighting side burner.
2. Make sure control knob is “OFF”.
3. With propane tank open, push and turn control knob to “HI”. Press igniter for
3-5 seconds.
4. If ignition does NOT occur in 5 seconds, turn control knob to “OFF”, wait
5 minutes to allow gas to dissipate and repeat lighting procedure.
5. If burner does not ignite using the igniter, see “Match Lighting the Side Burner”
section.
6. To turn o, turn control knob clockwise until it locks in “OFF” position.
Note: If burner does not light or ame is too low, See “Troubleshooting” section of the owners manual.
MATCH LIGHTING THE SIDE BURNER:
1. Open lid to the side burner before lighting.
2. Make sure control knob is “OFF”.
3. Place a paper match in end of the matchlighter. Strike match and hold it approximately 1/2" (1 of 2 cm)
from burner. (Figure B)
4. With LP cylinder open, push and turn the side burner control knob counter-clockwise to "HI" position.
Turn side burner control knob to “HI” position. The burner should light within 5 seconds.
5. If burner does not light, turn control knob to “OFF” and wait 5 minutes for gas to dissipate and repeat
lighting procedure.
6. If burner does not light within rst few attempts of match lighting, there is a problem with the gas supply.
Turn o gas at burner and cylinder. DO NOT attempt to operate grill until the problem is found and
corrected.
NOTE: If burner does not light or ame is too low, See “Troubleshooting”
section of the owners manual.
NOTE: Observe ame height when lit: Flame should be a Blue/Yellow color
between 1”–2” when burner is on “HI”.
See PROPER BURNER ASSEMBLY, pg.15, PROPER BURNER FLAME PATTERN, pg.15 and BLOCKED
BURNER VENTURI on pg.16.
Match Lighting Tool
A
B
C
To Next Page
Loading...
