1-833-454-0864
7
LP GAS CYLINDER (TANK) RUBBER SEAL INSPECTION:
• Inspect propane tank valve rubber seal for cracks, wear
or deterioration prior to use. A damaged rubber seal can
cause a gas leak, possibly resulting in an explosion, re
or severe bodily harm.
• Inspection should be done each time propane tank is
connected to grill, has been relled, exchanged or has
not been used for more than 60 days.
• Do not use a propane tank with a damaged rubber
seal. Exchange tank or have rubber seal replaced at a
qualied propane lling station.
INSTALLING THE LP GAS CYLINDER:
1. Check that the cylinder shut-o valve is closed
,
by turning knob clockwise.
2. Place cylinder into tank holder in bottom of cabinet.
3. Orient cylinder so valve opening faces forward.
4. Secure the tank using the tank retention screw.
WARNING
• DO NOT attempt to connect to any other fuel supply source such as natural gas.
• DO NOT use any other pressure regulator/hose assembly other than the one supplied with your
grill. Replacement pressure regulator/hose assembly(Part number G606-0008-C1), can
be obtained by contacting the customer care hotline at 1-833-454-0864.
• DO NOT attempt to adjust or repair a regulator. The regulator is designed to operate at a maximum
output pressure of 11 inches of water column (2.74 kPa).
• Ensure the tank valve is CLOSED prior to connecting the LP gas cylinder to your grill. Turn the
valve knob clockwise to properly close the valve. Read and follow all instructions and warnings
on the supply hose safety tags. Read and follow all warnings in this manual concerning the safe
use of LP gas cylinders and the hose and regulator before connecting cylinder to grill. Read and
follow all warnings on the LP cylinder.
Good
Rubber Seal
Damaged
Rubber Seal
HOSE & REGULATOR SPECIFICATIONS AND INSTALLATION:
Tank Retention Screw
To Next Page
Loading...
