Member's Mark PRO G54501 - Page 8

1-833-454-0864
8
HOSE AND REGULATOR:
Your grill is equipped with a Type 1 connection device with the following features:
1. The system will not allow gas ow from cylinder until a positive connection to valve has been made.
NOTE: The cylinder valve and all grill burner knobs must be turned OFF before any connection
is made or removed.
2. A regulator ow limiting device, when activated, restricts the ow of gas to 10 cubic feet per hour. If the
ow limiting device is activated, perform Regulator Reset Procedure.
NOTE: If you are experiencing performance issues such a low heat, low ame, or di󰀩culty lighting, you have
likely tripped your regulators ow limiting feature. Follow steps for Regulator Reset, on page 9.
3. A thermal element built into the regulator supply hose will shut the ow of gas between
240 degrees
‒
300 degrees F.
CONNECTING HOSE AND REGULATOR:
1. Inspect propane tank valve rubber seal for cracks, wear or deterioration
prior to use. A damaged rubber seal can cause a gas leak, possibly
resulting in an explosion, re or severe bodily harm. Do not use a propane
tank with a damaged rubber seal.
2. Check that the grill’s burner control knobs are “OFF”.
3. Check that the cylinder valve is closed by turning knob clockwise.
4. Position the LP tank into the BBQ cart and secure with the tank screw..
5. Remove the protective plastic cap from cylinder valve.
6. Check that the hose does not contain kinks, and ensure that the supply hose does not come in contact
with any sharp edges.
WARNING: Ensure that the supply hose does not come in contact with the heat shield above.
7. Connect the Type 1 regulator coupling to the cylinder valve, turning clockwise. Hold the regulator in a
straight line with the LP cylinder when connecting. Take care not to cross thread. Hand-tighten only.
8. Leak check all ttings before lighting your grill. See section on “Leak Testing” in this manual.
NOTE: To remove regulator from propane tank, turn o󰀨 tank valve and rotate large coupling nut
counter-clockwise.
Inspect Rubber Seal (see page 7)
ATTENTION: Visually inspect hose prior to each use for damage, excess
wear, or deterioration. If found, replace hose before using your grill. Only
the manufacturer’s supplied replacement should be used.