Memmert WTB - Disposing of packaging material; Setting up

15 03/2021
Delivery, Transport and Setting Up
3.2.1 Product control
■ Check the delivery note to ensure that the scope of delivery is complete
■ Check the appliance for damage
If you notice deviations from the scope of delivery, damage or irregularities, do not put
the appliance into operation but inform the haulage company and the manufacturer.
3.3 Disposing of packaging material
■ Dispose of the packaging material (cardboard, wood, foil) in accordance with the appli-
cable disposal regulations for the respective material in your country
3.4 Setting up
If the appliance is set up on an uneven surface, it can fall over and injure you or other
people. Always place the appliance on an even, load-bearing and non-slip surface.
The surfaces of the appliance can overheat during operation and overheat heat-sen-
sitive surfaces in close proximity to the appliance. Always place the appliance on a
heat-resistant surface and maintain the specied clearance around the appliance.
The distance between the wall and the rear of the appliance must be at least 15 cm. The
clearance from the ceiling must not be less than 75 cm and the side clearance from
walls or nearby appliances must not be less than 10 cm. Sufcient air circulation in the
vicinity of the appliance must be guaranteed at all times.
CAUTION
CAUTION
memmert
10 cm
10 cm
15 cm
10 cm
75 cm