Memmert WTB - Putting into operation; Putting into operation for the first time; Connect the appliance to the power supply; Filling

17 03/2021
Putting into operation
4. Putting into operation
4.1 Putting into operation for the rst time
NOTICE
When putting the appliance into operation for the rst time, do not leave it unattended
until it has reached a steady state.
For connection, please observe the national regulations. Observe the connection and
power ratings (see name plate and technical data). Make sure to establish a safe PE
conductor connection.
4.2 Connect the appliance to the power supply
Place the power cable so that
■ it does not represent a trip hazard
■ it cannot come into contact with any hot parts
■ it is easily accessible at all times and can be pulled off quickly, for example in case of
interference or an emergency
4.3 Filling
NOTICE
Observe the following points before lling the water bath:
■ Water bath may not be operated while empty
■ Check that the outlet valve is closed before lling
■ Observe the minimum ll level for the water bath
■ Observe the maximum lling level when lling and loading the water bath, which is
marked by the edge in the water bath tray
Large WTB Filling level
6
min. 4 cm
11
15
min. 2 cm
24
35
50
memmert
MIN
MAX