MyChron 3 and the computer
MyChron 3 has a non volatile RAM memory which guarantees the capacity to
record up to 250 laps at a sampling frequency of 10 Hz ( ten times per second ).
MyChron 3 has been designed and developed to be interfaceable with a Pc:
through an USB cable it is possible to connect MyChron 3 to a PC in order to
both download the data stored in memory and configure your instrument.
Aim reminds all MyChron 3 owners that, for a correct, complete and easier
instrument configuration, it is absolutely necessary to use a PC and program
Race Studio 2. This software has been properly developed by Aim in order to
interface all its products ( Drack, EVO 3, MyChron 2, MyChron 3,
MyChron PRO and Dash ST1 ) with the PC.
It is reminded that the new software installation does not either cancel or
influence the functionalities of Race Studio. Once installed the program, the
user will be able to choose if to use the new software even with his old Aim
products ( all supported by Race Studio 2 ) or if to keep on using the previous
program.
In the following pages it will be shown how to install the software on your
PC and how to correctly configure your MyChron 3 by using a PC.
36