Utility functions
Once configured your system, you are ready to manage the data you have
acquired with your gauge. MyChron 3 records lap time, RPM and temperature at
a sampling rate of 10 Hertz ( ten times per second ). This data can be retrieved
at a later stage for analysis.
MyChron 3 segments data for a session as a test and each test includes the
laps completed in that session. To begin recording a new test, please turn off
your system off by pressing buttons MEM and VIEW simultaneously, and then
turn the system back on.
Viewing data
while driving
The MyChron 3 will display “Test 01” or the current test number
if memory has not been cleared, and “Lap 001” once the
magnetic sensor passes over a magnetic strip ( or the infrared
receiver passes the beacon transmitter ).
If the system has been configured to capture back segments
using the number of splits option, the system will display “Split
Number x”, up to the number of splits selected. Once the
system records times for each split, the final segment is
displayed as a completed lap.
At the same time the system displays the time difference
between the current split time and the split time of the previous
lap.
When the system records the best lap time for a test, the text
“Best Lap Time” will appear on the display.
31
To Next Page
Loading...
Need help?
General