When a test is complete, the system displays the last lap number and last lap
time. Using button MEM you will access the data stored in system’s memory.
Let’s now see how to retrieve data after the completion of a test
Viewing data
per best lap
time
To view the data for the lap with the best lap time, press MEM
while in general display mode. The best lap time is displayed
for the most recent test.
The system displays the test number, lap number, maximum
temperature for the lap and the lap time. The lap time will be
flashing, signaling that this is the best lap time for the test.
If button MEM is pressed a second time, it will appear the
minimum temperature and RPM values for the lap with the
best time.
To return to general display mode, press VIEW.
View other
completed lap
data
To view completed lap data, while in general display mode,
press button MEM to view the best lap time. Then press
button MENU/<< to view a previous lap or button >> for a
following lap. If you have configured the MyChron 3 to
capture splits, buttons MENU/<< and >> will also scroll
through the split times within each lap.
Pressing button MEM you will see the minimum RPM and
temperature values for the current lap.
To retrieve previous test data ( when more than one test has
been recorded ) press button MENU/<< until the required test
32
To Next Page
Loading...
Need help?
General