Memotec mychron 3 - Replaying detailed data for the lap

To Next Page

To Previous Page

and lap details ( or split details ) appear on the display.

To increase scrolling speed through recorded laps hold down

buttons MENU/<< and >>.

Replaying

detailed data

for the lap

If you wish to replay detailed data for a lap, you may choose

between an AUTOMATIC way and a MANUAL one.

Automatic lap replay: while in general display mode, press

button MEM; then, using buttons MENU/<< or >> choose the

lap you wish to see and then press twice button MEM: the

system will automatically replay the graphic and decimal RPM,

thermocouple temperature and lap time from start to finish in

time intervals of one-tenth of a second ( 10 Hertz → 10 data

points per second ).

To stop the automatic lap replay press MEM. To return to

general display mode press VIEW again.

Manual lap replay: to manually step through the detailed lap

data, while the system is in general display mode, press MEM;

then, using buttons MENU/<< or >> choose the desired lap

and then press twice button MEM. The system will go to the

“automatic lap replay” mode.

Now press >> or MENU/<< to stop the automatic replay; use

button MENU/<< to decrease the progressive lap time by one-

tenth of a second and button >> to increment the progressive

lap time by one-tenth of a second.