If you wish to delete the previous configuration, please press button Si,
otherwise press button No and, then, choose the Receive option. By using this
option you will be able to download and save the configuration previously stored
in the instrument’s memory.
Once saved the previous configuration on your PC’s hard disk you can restart
the configuration transmission procedure.
Once the configuration has been correctly transmitted to the Dash ST1, on your
PC’s monitor it will appear the following window:
Now, in order to control that every channel has been correctly configured, it is
suggested to enter Online mode and to verify if the channels properly work.
If, during configuration or transmission, you notice any problem, it is
recommended to repeat the configuration procedure.
51
To Next Page
Loading...
Need help?
General