STORAGE
94 eng
4. Premix the following in a container:
• 8 cc (0.27 oz) or two teaspoons of Mercury Precision
Quickleen lubricant.
• 8 cc (0.27 oz) or two teaspoons of Mercury Precision
Fuel Stabilizer.
5. Pour this mixture in a new water separating fuel filter. Install
the fuel filter.
6.
Prime the fuel system as outlined in Operation ‑ Starting
the Engine.
7. Place the outboard in water or use the flushing attachment
for circulating cooling water. Start the engine and run at idle
speed for 10 minutes to allow the treated fuel to fill the fuel
system.
Flushing Device 91‑44357Q 2
Attaches to the water intakes;
provides a fresh water
connection when flushing the
cooling system or operating
the engine.
Protecting Internal Engine Components
NOTE: Make sure the fuel system has been prepared for
storage. Refer to
Fuel System
, preceding.
IMPORTANT: Refer to Spark Plug Inspection and
Replacement for correct procedure for removing spark plug
leads.
1. Remove the spark plugs. Add approximately 30 ml (1 oz) of
engine oil or inject a five second spray of storage seal into
each spark plug hole.
2. Rotate the flywheel manually several times to distribute the
oil or storage seal in the cylinders.
3. Reinstall spark plugs.
To Next Page
Loading...
Need help?
General