MAINTENANCE
eng 77
Description Nm lb‑in. lb‑ft
Nylon insert locknut "c"
Tighten until it seats, then back off 1/4
turn
Assemble steering link rod to steering cable with two flat
washers and self‑locking nylon insert locknut. Tighten locknut
until it seats, then back nut off 1/4 turn.
Assemble steering link rod to engine with special washer head
bolt and self‑locking nylon insert locknut. First torque bolt, then
torque locknut to specifications.
Fuse Replacement
IMPORTANT: Always carry spare 5 and 20 AMP fuses.
The electrical wiring circuits on the outboard are protected from
overload by fuses in the wiring. If a fuse is blown, try to locate
and correct the cause of the overload. If the cause is not found,
the fuse may blow again.
To Next Page
Loading...
Need help?
General