Mercury 175 Pro XS OptiMax

OPERATION
64 eng
1. Lower the outboard to the vertical operating position. Make
sure all cooling water intake holes are submerged.
3405
2. Open fuel tank vent screw (in filler cap) on manual venting
type fuel tanks.
19748
3. Position the fuel line primer bulb so the arrow on the side of
the bulb is pointing up. Squeeze the fuel line primer bulb
several times until it feels firm.
27348
4. Set the lanyard stop switch to "RUN" position. Refer to
General Information ‑ Lanyard Stop Switch.
19791