EasyManuals Logo

Mercury 200 Operation And Maintenance Manual

Mercury 200
60 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #38 background imageLoading...
Page #38 background image
OPERATION
32
ob01079
Engine Break‑in Procedure
!
CAUTION
Severe damage to the engine can result by not complying with the Engine Break‑in Procedure.
GASOLINE/OIL BREAK-IN MIXTURE
Do not use pre‑mixed gas and oil during break‑in. Oil from the oil injection system will supply adequate lubrication
during engine break‑in.
BREAK-IN PROCEDURE
1. For the first hour of operation, allow the engine to warm up for 30‑60 seconds.
a. Run the engine at varied throttle settings, the majority of the time between 3000 and 4500 RPM or
three‑quarter throttle.
b. Change engine speed approximately every two minutes, and avoid continuous operation at idle speed
for more than ten minutes. Short bursts of full throttle for periods up to ten seconds are acceptable.
c. Avoid trimming the outboard out (up) beyond a vertical trim position during operation.
NOTE: It is the driver's responsibility to always drive in a safe manner. Improper trim angle of the outboard when
driving at the proper speed can be difficult and dangerous. The purpose of specifying trim angle is to help guide
the operator in determining how to put the proper load on the engine.
2. For the next three hours of operation, change engine speed every ten minutes.
Starting The Engine
Before starting, read the Pre‑Starting Check List, Special Operating Instructions, and Engine Break‑in Procedure
in the Operation Section.
!
CAUTION
Never start or operate your outboard (even momentarily) without water circulating through all the cooling water
intake holes in the gearcase to prevent damage to the water pump (running dry) or overheating of the engine.
1. Lower the outboard to the vertical operating position. Make sure all cooling water intake holes are
submerged.

Table of Contents

Other manuals for Mercury 200

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mercury 200 and is the answer not in the manual?

Mercury 200 Specifications

General IconGeneral
Fuel Induction SystemElectronic Fuel Injection (EFI)
Displacement3.0L (181 cubic inches)
Horsepower200 HP
Alternator Output60-amp
Shaft Length20", 25"
SteeringHydraulic
Weight505 lbs (20" shaft), 515 lbs (25" shaft)
Starting SystemElectric

Related product manuals