Mercury 200 User Manual

MAINTENANCE
69
3. Set the spark plug gap to specifications.
27848
Spark Plug Gap
Spark plug 0.90 mm (0.035 in.)
4. Before installing spark plugs, clean off any dirt on the spark
plug seats. Install plugs finger tight, and then tighten to the
specified value.
Description Nm lb. in. lb. ft.
Spark plug 27 20
Lubrication Points
1. Lubricate the following with Quicksilver or Mercury Precision
Special Lubricant 101.
Tube Ref No. Description Where Used Part No.
34
Special Lubricant 101 Trim rod ball ends
92-802865Q0
2
• Trim Rod Ball Ends ‑ Turn the ball ends to work the
lubricant into the ball sockets.
28458
2. Lubricate the following with Quicksilver or Mercury Precision
Lubricants Anti‑corrosion Grease or 2‑4‑C with Teflon.

Mercury 200 Specifications

General

Fuel Induction System	Electronic Fuel Injection (EFI)
Displacement	3.0L (181 cubic inches)
Horsepower	200 HP
Alternator Output	60-amp
Shaft Length	20", 25"
Steering	Hydraulic
Weight	505 lbs (20" shaft), 515 lbs (25" shaft)
Starting System	Electric