Mercury 200 User Manual

OUTBOARD INSTALLATION
108
5. Reinstall the cowl seal.
a
29075
a - Retainer
Filling the Fuel System
When starting an engine for the first time, or starting an engine that
ran out of fuel or was drained of fuel, fill and prime the fuel system.
To fill and prime the fuel system:
1. Squeeze the fuel line primer bulb until it feels firm.
2. Turn the key switch to the "ON" position for three seconds.
This operates the electric fuel pump.
3. Turn the key switch back to the "OFF" position and squeeze
the primer bulb again until it feels firm.
4. Turn the key switch to the "ON" position again for three
seconds.
5. Continue this procedure until the fuel line primer bulb stays
firm.

Mercury 200 Specifications

General

Fuel Induction System	Electronic Fuel Injection (EFI)
Displacement	3.0L (181 cubic inches)
Horsepower	200 HP
Alternator Output	60-amp
Shaft Length	20", 25"
Steering	Hydraulic
Weight	505 lbs (20" shaft), 515 lbs (25" shaft)
Starting System	Electric