Mercury 200 User Manual

MAINTENANCE
72
• Steering Cable Grease Fitting (if equipped) ‑ Rotate
steering wheel to fully retract the steering cable end into
the outboard tilt tube. Lubricate through fitting.
a
b
27875
a - Fitting b - Steering cable end
4. Lubricate the following with light weight oil.
• Steering Link Rod Pivot Points ‑ Lubricate pivot points.
27876
Checking Power Trim Fluid
1. Tilt outboard to the full up position and engage the tilt support
lever.
27877

Mercury 200 Specifications

General

Fuel Induction System	Electronic Fuel Injection (EFI)
Displacement	3.0L (181 cubic inches)
Horsepower	200 HP
Alternator Output	60-amp
Shaft Length	20", 25"
Steering	Hydraulic
Weight	505 lbs (20" shaft), 515 lbs (25" shaft)
Starting System	Electric