Mercury 200 User Manual

MAINTENANCE
75
4. Stop adding lubricant. Install the vent plug and sealing washer
before removing the lubricant tube.
5. Remove lubricant tube and reinstall cleaned fill/drain plug and
sealing washer.
Submerged Outboard
A submerged outboard will require service within a few hours by
an authorized dealer once the outboard is recovered from the
water. This immediate attention by a servicing dealer is necessary
once the engine is exposed to the atmosphere to minimize internal
corrosion damage to the engine.

Mercury 200 Specifications

General

Fuel Induction System	Electronic Fuel Injection (EFI)
Displacement	3.0L (181 cubic inches)
Horsepower	200 HP
Alternator Output	60-amp
Shaft Length	20", 25"
Steering	Hydraulic
Weight	505 lbs (20" shaft), 515 lbs (25" shaft)
Starting System	Electric