EasyManuals Logo

Mercury 200 User Manual

Mercury 200
118 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #85 background imageLoading...
Page #85 background image
TROUBLESHOOTING
79
Starter Motor Will Not Crank the Engine
POSSIBLE CAUSES
Blown 20 amp fuse in the starting circuit. Refer to
Maintenance.
Outboard is not shifted to neutral position.
Weak battery or battery connections are loose or corroded.
Ignition key switch failure.
Wiring or electrical connection faulty.
Starter motor solenoid or slave solenoid failure.
Engine Will Not Start
POSSIBLE CAUSES
Lanyard stop switch not in "RUN" position.
Incorrect starting procedure. Refer to Operation section.
Old or contaminated gasoline.
Engine flooded. Refer to Operation section.
Fuel is not reaching the engine.
Fuel tank is empty.
Fuel tank vent not open or restricted.
Fuel line is disconnected or kinked.
Primer bulb not squeezed.
Primer bulb check valve is faulty.
Fuel filter is obstructed. Refer to Maintenance section.
Fuel pump failure.
Fuel tank filter obstructed.
Open 20 Amp fuse. Refer to Maintenance section.
Ignition system component failure.
Wiring or electrical connection faulty.
Spark plugs fouled or defective. Refer to Maintenance section.

Table of Contents

Other manuals for Mercury 200

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mercury 200 and is the answer not in the manual?

Mercury 200 Specifications

General IconGeneral
Fuel Induction SystemElectronic Fuel Injection (EFI)
Displacement3.0L (181 cubic inches)
Horsepower200 HP
Alternator Output60-amp
Shaft Length20", 25"
SteeringHydraulic
Weight505 lbs (20" shaft), 515 lbs (25" shaft)
Starting SystemElectric

Related product manuals