FEATURES AND CONTROLS
46
If a failure should occur while underway which causes the starboard outer engines into forced neutral/
idle condition, the inner starboard engine will also be forced to neutral/idle. Operation to the inner engine
can be restored by moving the starboard control handle back into neutral and then re-engaging.
If a failure should occur while underway which causes the port outer engines into forced neutral/idle
condition, the inner port engine will also be forced to neutral/idle. Operation to the inner engine can be
restored by moving the port control handle back into neutral and then re-engaging.
TRIM SWITCH AND KEY PAD FEATURES
1. Trim switch (if equipped) - Operates the trim for all engines. An accessory trim switch panel is
required for trimming engines individually.
2. Neutral lights - The neutral lights illuminate when the engine is in neutral gear position. The lights
will flash when the engine is in throttle only mode.
NOTE: Gear position is determined by the position of the shift actuator on the engine, not the position
of the control handle.
3. Troll button - Pressing the "TROLL" button activates troll control. The troll control feature allows
the boat operator to set the engine speed for slow speed cruising or maneuvering. To activate,
move the control handles into forward detent and press the button. Use the - or + buttons to
decrease or increase speed, up to the maximum calibrated set point. If troll control is set at a
desired speed and then shut off, the system remembers the set speed and will return to that speed
when re-engaged. To turn off the troll control press the "TROLL" button, move the throttle to a
different speed, or shift the engine into neutral.
4. Transfer button - Pressing the "TRANSFER" button allows engine operation to be transferred to
a different helm. Refer to Helm Transfer.
5. Dock button - Pressing the "DOCK" button initiates docking mode. Docking mode reduces throttle
capacity to approximately 50% of normal throttle. To turn off docking mode, shift the engine into
neutral and press the "DOCK" button.
6. Throttle only button - Allows the boat operator to increase engine RPM for warm-up, without
shifting the engine into gear. To engage throttle only, move the control handle into the neutral
position. Press the throttle only button while moving the control handle ahead to the forward
detent. The horn will sound once and the neutral light will start flashing. The horn will sound twice
when throttle only is engaged. Advance throttle to increase engine RPM. To disengage, return
control handle to neutral position and press the throttle only button. Engine RPM is limited to
prevent engine damage.
7. 1 lever button - Pressing the "1 LEVER" button initiates single lever mode. Single lever mode
enables the throttle and shift functions of both engines to be controlled by the port control handle.
To turn off single lever mode, shift the engine into neutral and press the "1 LEVER" button.
To Next Page
Loading...
