MAINTENANCE
75
Crankcase Oil Pump 91-90265A 5
Aids in the removal of engine oil without
draining the crankcase.
DRAIN METHOD
1. Tilt the outboard out/up past vertical for approximately one minute to allow any trapped oil to drain
back to the oil sump.
2. Place the outboard in a vertical position.
3. Place an appropriate container under the engine oil sump plug. The drain plug/seal washer is
located beneath the splash plate on the port side of the outboard.
4. Loosen the drain plug/seal washer. Install the oil drain funnel over the drain plug/seal washer.
a - Drain plug/seal washer b - Oil drain funnel
Oil Drain Funnel 91-892866A01
Diverts draining engine oil from
contacting the anti-splash and anti-
cavitation plates.
5. Remove drain plug/seal washer and drain the engine oil into a container.
6. Reinstall the drain plug/seal washer.
CHANGING OIL FILTER
IMPORTANT: To reduce or prevent oil spillage when removing the oil filter, ensure that the outboard is
upright (not tilted) and the engine is cold or has not run for at least one hour.
1. Remove the top cowl.
2. Place a rag or towel below the oil filter to absorb any spilled oil.
To Next Page
Loading...
