4. Ensure that the gasket is installed on the top vent screw.
IMPORTANT: Replace the gasket if damaged.
5. Install the top gearcase vent screw and tighten to the specified torque.
Description Nm lb‑in. lb‑ft
Top gearcase vent screw 11.3 100 –
6. Ensure that the gasket is installed on the lower drain screw.
IMPORTANT: Replace the gasket if damaged.
7. Remove the lubricant fill connection and quickly install the lower gearcase
drain screw. Tighten the screw to the specified torque.
Description Nm lb‑in. lb‑ft
Lower gearcase drain screw 11.3 100 –
Transmission Fluid
RECOMMENDED TRANSMISSION FLUID
Mercury or Quicksilver Automatic Transmission Fluid is recommended. If the
recommended Mercury or Quicksilver fluid is not available, use a Dexron III
fluid listed in the ZF specification TE‑ML 04D as an alternative.
TRANSMISSION FLUID CAPACITY
Transmission Fluid Capacity without filter change
5.7 L (6.0 US qt)
PREVENTING TRANSMISSION FLUID LEVEL READING ERRORS
The vent filter at the top of the transmission vent tube can become fouled,
creating a vacuum that can result in incorrect fluid level readings. Mercury
recommends removing the vent filter prior to reading the transmission fluid
level.
a - Transmission fluid dipstick
b - Vent filter
c - Transmission vent tube
MAINTENANCE
eng 103
To Next Page
Loading...
