10. Close the hood.
Cooling System Water Strainer Inspection
IMPORTANT: The water strainer is an integral component of the cooling
system. It should be inspected every 1000 hours of operation.
1.
Remove the top cowl. Refer to Top Cowl Removal and Installation.
2. Locate the water strainer on the lower rear starboard side of the engine.
3. Remove the two screws securing the water strainer cap. Turn the cap
counterclockwise and pull the strainer up and out of the housing by hand
or using a wrench.
4. Inspect the strainer for debris, blockage, or accumulation of mineral
deposits. Spray the strainer with fresh water or use a nylon bristle brush
to help remove debris, blockage, or mineral deposits. If the strainer
cannot be cleaned or is damaged, replace the strainer.
5. Insert the clean strainer into the fitting on the engine.
6. Secure the strainer cap with two screws. Tighten the screws to the
specified torque.
MAINTENANCE
eng 109
To Next Page
Loading...
Need help?
General
