EasyManua.ls Logo

Mercury GO BOLDLY SeaPro 500hp

Mercury GO BOLDLY SeaPro 500hp
135 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Starter Motor Will Not Crank the Engine
POSSIBLE CAUSES
Lanyard stop switch not in RUN position.
Open clean power harness circuit fuse. Refer to Maintenance section.
Remote control is not shifted to the neutral position.
Shift actuator failure. Turn ignition key switch OFF to reset and then start
the engine.
Weak battery or battery connections are loose or corroded.
Ignition key switch failure.
Wiring or electrical connection faulty.
Starter motor solenoid or starter relay failure.
Engine Will Not Start
POSSIBLE CAUSES
Incorrect starting procedure. Refer to Operation section.
Old or contaminated gasoline.
Fuel is not reaching the engine.
Fuel tank is empty.
Fuel tank vent not open or restricted.
Fuel line is disconnected or kinked.
Fuel filter is obstructed. Refer to Maintenance section.
Fuel pump failure.
Fuel tank filter obstructed.
Ignition system component failure.
Spark plugs fouled or defective. Refer to Maintenance section.
Engine Starts But Will Not Shift Into Gear
Throttle only mode is engaged.
Transmission failure. Turn ignition key switch OFF to reset and then start
the engine.
Engine Runs Erratically
POSSIBLE CAUSES
Overheating—warning horn not working.
Low oil pressure. Check oil level.
Spark plugs fouled or defective. Refer to Maintenance section.
Incorrect setup and adjustments.
Fuel is being restricted to the engine.
TROUBLESHOOTING
eng 119

Table of Contents

Related product manuals