6. Remove the electrical latch connector from the bracket on the oil dipstick
tube.
a - Oil dipstick tube
b - Bracket
c - Electrical latch connector
7. Connect the electrical latch connector to the hood latch.
a - Hood latch
b - Electrical latch connector
8.
Install the hood. Refer to Hood Installation.
Flushing the Cooling System
Flush the internal water passages of the outboard with fresh water after each
use in salt, polluted, or muddy water. This will help prevent a buildup of
deposits from clogging the internal water passages.
TRADITIONAL FLUSHING
1. With the engine turned off, place the outboard in a convenient position.
MAINTENANCE
84 eng
To Next Page
Loading...
