• Panel mount and single‑handle electronic remote controls require the
operator to press the mechanical lock bar while moving the control handle
out of the neutral position.
a - Mechanical lock bar—panel
mount ERC
b - Mechanical lock bar—
single‑handle ERC
• Always shift the outboard into gear with a quick motion.
• After shifting the outboard into gear, advance the lever further to increase
speed.
ZERO EFFORT CONTROL GEAR SHIFTING
1. Verify the throttle lever is at the idle position.
2. Move the shift lever forward or reverse.
3. Advance the throttle lever to apply power.
a - Shift levers in neutral position
b - Trim switch
c - Throttle levers at the idle position
Stopping the Engine
IMPORTANT: Turning key to the START position while the engine is running
will result in engine shut down, while leaving the DTS system active. This will
allow the use of the power trim/tilt from the remote control handle.
OPERATION
66 eng
To Next Page
Loading...
Need help?
General
