Mercury V6 200 User Manual

• CO family emissions level
• Recommended spark plug and gap
• Percent of fuel line permeation
Service Replacement EPA Decal
IMPORTANT: By federal law, it is required that all 1998 and newer Mercury Marine outboards have a visible and legible
emission certification decal. If this decal is missing or damaged, contact Mercury Marine Service for a replacement.
Removal
Remove all remaining pieces of the damaged or illegible decal. Do not install the new decal over a damaged old decal. Use a
suitable solvent to remove any traces of the old decal adhesive from the display location.
NOTE: If the original decal surface is in good condition, it is acceptable to clean the surface and apply the new decal over the
original.
Installation
Apply the decal on a clean surface in the original factory location.
Emissions
Page 1C-4 © 2018 Mercury Marine 90-8M0146617 eng JULY 2018

Mercury V6 200 Specifications

General

Engine Type	V6
Horsepower	200 hp
Fuel Induction System	Electronic Fuel Injection (EFI)
Steering	Big Tiller; Dual cable mechanical; Electro-hydraulic power steering; Hydraulic power steering
Gear Ratio	1.85:1
Shaft Length	20"; 25"
Starting	Electric
Alternator Output	60 amps
Weight	505 lbs (20")