To Next Page

To Previous Page

COMBINING TO CAN-BUS SYSTEM

CAN-BUS line connection

for standard two-wire system

CAN-BUS line connection

for single-wire system

RED/BLACK BLACK/PURPLE

SPECIAL FUNCTIONS AVAILABLE ONLY FOR PRODUCT EasyCan Digital

AUTOMATIC INHIBITION OF ULTRASONIC VOLUMETRIC PROTECTION

For some applications of the EasyCan Digital product., automatic inhibition of ultrasonic protection is available in the

event of the car windows being open when the alarm is engaged.

If a window is open when the alarm is engaged, the EasyCan Digital unit will signal this with a BOOP and, after the

vehicle has been closed, will cut out the volumetric protection and notify the user with the same signals provided for

voluntary inhibition after vehicle closing.

The windows open signal (beep at activation) and automatic inhibition can be excluded using the

portable PDC /Alarm Programmer.

For a FINAL CHECK OF VOLUMETRIC PROTECTION on cars with automatic inhibition, the ultrasonic

check test must be performed with closed windows.

EMERGENCY DEACTIVATION USING THE TRANSPONDER OF THE ORIGINAL REMOTE CONTROL

In some of the CAN-BUS protocols available for the EasyCan Digital product, the emergency function with

transponder is available.

This function makes it possible to avoid the use of additional electronic keys by exploiting the recognition of the

transponder chip included in the original remote control.

To deactivate the alarm in emergency condition, simply activate the instrument panel using the original key and

wait a few moments until the transponder chip is recognised.

The deactivation function by transponder is present in many product CAN-BUS protocols

EasyCan Digital and the information for  tting on individual vehicles are available ONLINE on website

www.metasystem.it in the CAR-ALARM technical area.

To check the protection of the ignition stop simulating a start attempt with product engaged, the vehicle key

transponder must be shielded (e.g., using silver paper) to prevent the insertion of the key disengaging the product

and consequently the ignition stop.

(The deactivation function by means of transponder can be cut out using the portable PDC/ Alarm Programmer

inside the module set-up menu).

Meta System EasyCan Digital User Manual

Questions and Answers: