Metacon-Next FirePro V4 - Page 44

44
Parameter
Description
Settings
2.5) Obstacle detection; activated if the photocell and/or safety
edge input is interrupted/activated for a configured time
(parameter 5.4).
5.3 Choice after
deactivation fire
alarm(s)
(Terminals X 16 )
.1) Door closes until an open button, sensor input or stop button is
operated.
X
.2) Door stops immediately.
5.4
Time
obstacle
detection
1 to 60 minutes.
1
min.
5.5 Function
LED/buzzer signal
transmitter.
.1) For all error messages and fire alarm/emergencies.
Only activate again after longer than 30 seconds for photocell
and/or safety edge.
X
.2) For all error messages and emergencies.
.3) Only for fire alarm/emergency.
.4) Off.
5.7 Type fire alarm
input 2
.1) 8.2kΩ resistor.
X
.2) Potential-free NC contact.
5.8 Reverse direction
of rotation (motor
with NES)
.1) Retain direction of rotation.
X
.2) Reverse direction of rotation.
5.9 Pass door/slack
cable
.1) 5,1kΩ resistor
X
.2) Potential-free NC contact.