If using MIG Dispensers, use the following procedure:
Open the Mig Dispenser and if attached, unscrew the retaining
nut.
Load the Wire for spraying into the Mig Dispenser Reels with
the wire feeding from the bottom of the reel.
Screw on the retaining nut.
Straighten the first 150mm.
Using a file, smooth off any sharp edges on the wire end. This
will dramatically improve the performance and life of the Wire
Conduits and aid feeding the wire into the pistol.
Ensure that the drive roller tension is released by pulling the
Fixing Arm Tensioners down on both sides of the unit.
Allow 50mm to protrude through the Unit. Then pull down
the Bearing Pressure Arms and close with the Fixing Arm
Tensioners.
Attach an absorbent strip for wire lubricant to both reels and
apply approximately 5ml of lubricant to each strip.
To Next Page
Loading...
