Page 7 of 48
1.1 Safety Precautions
Provided that the equipment is properly set up, regularly maintained and used correctly, metal
spraying does not present any great danger. However, like most industrial processes, misuse
and careless practices can create hazards for personnel and damage to the equipment.
The equipment detailed in this manual will produce levels of noise, UV light and dust that
require safety measures to be taken by personnel using the equipment. Careful consideration
should be taken when positioning this equipment.
It is the responsibility of the user to ensure that all appropriate measures are in place for safe
operation, before the equipment is used. Metallisation will be pleased to assist and advise as
appropriate.
1.1.1 Equipment Dos and Don’ts
Ensure that all appropriate Risk Assessments are carried out before using this equipment.
Ensure the equipment is properly set up as per Section 3.1 of this Manual.
NEVER point the pistol towards other personnel or combustible material.
NEVER spray onto hoses, cables or instruments.
NEVER operate the pistol without using ear defenders and the appropriate eye protection.
NEVER look into the arc zone, without first ensuring that the power switch is in the "off"
position and the drive motor is switched off.
1.1.2 Handling of the Energiser
The Energiser must only be lifted from the base, under no circumstances should it be lifted by
the handle or by the M12 thread that locates the dispenser spigot.
Care must be taken if attempting to transport the Energiser by fork lift truck not to damage the
underside of the unit.
1.1.3 The Energiser Mains Supply
The mains supply MUST be disconnected before removing any of the outer panels.
Isolate the mains supply.
ALL maintenance or overhaul should be conducted by a fully qualified electrician in
accordance with local regulations.
To Next Page
Loading...