Metallisation ARC150-2310D - CG Spray Head - Checking Contact Tips

Page 30 of 48
4.2 CG Spray Head – Checking Contact Tips
Remove the Air Cover by unscrewing in the direction shown.
3
Remove the Air Cap by pulling forward.
4
If not already
removed, loosen
the Pointed Shroud
Screw and remove
the Shroud by
pulling forward.
1
NOTE: Before attempting to disassemble the Spray Head always ensure that the mains power supply is isolated and the wire has
been removed from the pistol.
Loosen the Thumb Screw
and remove the Hood.
2