Locker Controller ELS & ELS SELECT Technical Manual
STEP 5: Electronic Lock unlocks and the locker opens.
STEP 6: Unlocking time in milliseconds is displayed
shortly after locker index. Unlocking time should be
between 150 and 300.
NOTE
You can repeat this procedure on all lockers connected
to Locker Controller board.
Closing Lockers for transportation
By pressing the parameter request pushbutton you
toggle between “close” (CLOS) and “close & open”
(CLOP) mode of operation. After the pushbutton is
pressed “CLOS” or “CLOP” is displayed, indicating the
current mode of operation.
NOTE: When you start the TEST mode the device is in
“close & open” mode of operation.
STEP 1: To close the lockers for transportation select
“CLOS” by pressing the parameters request pushbutton.
To Next Page
Loading...
