Need help?Do you have a question about the Metrohm Autolab and is the answer not in the manual?
General| Software | NOVA |
|---|---|
| Current Range | 1 pA to 1 A |
| Voltage Range | ±10 V |
| Interface | USB, Ethernet |
| Compliance | CE |
Provides step-by-step instructions for setting up a TDI RBL 488 series electronic load.
Provides step-by-step instructions for setting up a Kikusui PLZ164WA electronic load.
Explains conversion settings and factors for controlling the TDI RBL 488 load.
Explains conversion settings and factors for controlling the Kikusui PLZ164WA load.
Describes how to specify the instrument configuration in NOVA software.
Details conversion settings for measuring current from external electronic loads.
Explains conversion settings for controlling the current setpoint of the electronic load.
Guides on how to manually control the electronic load via the Autolab display.
Explains how to adjust discharge current setpoints using NOVA procedures and commands.
Describes how to sample and record the electronic load's output using NOVA software.
Details requirements and commands for impedance spectroscopy measurements.
Defines conversion factor for the ← V signal between FRA module and electronic load input.
To Next Page
