Autolab/Electronic load combination
3 | Page
•
Constant power (CP) mode:
current is drawn from the cell until the
output power reaches a specified value.
•
Constant resistance (CR) mode:
current is drawn from the cell until the
resistance to the current flow reaches the specified value.
The
mode is the most suitable for the combination with the
Autolab, however the other modes are also available but these modes are affected
by ohmic losses and are therefore not accurate.
When the Autolab is combined with an electronic load, the Autolab will only be
used to control the load and measure the cell voltage. The specifications of the
Autolab are therefore irrelevant for this application and only the specifications
of the electronic load must be selected carefully (see Section 1). The Autolab
PGSTAT204/FRA32M is suitable for all the measurements described in this
manual.
To Next Page
Loading...
