Slurry Pump
WH08AAAAAA0EN_06B.DOC JAN 04-W24
Description
1/1
2.5 Surface treatment
2.5.1
Standard finish
The external surfaces of the pump are protected by the anti-corrosive system specified in
Table 2.5.1-1, except exposed machined surfaces which are coated with an air drying rust
inhibitor. Drive motors are supplied in the original manufacturer’s standard finish.
Stainless steel, plastic or elastomeric parts are not painted.
Table 2.5.1-1 Paint specification
COATING TYPE COLOUR Finish 70
DFT (µm)
Finish
(all except
guards)
Two-pack gloss
oxiranester thick coat
paint
Blue
(RAL 5009)
Gloss 120
Finish
(guards only)
Epoxy powder Yellow
(RAL 1032)
Gloss 100
2.5.2 Paint repairs
To repair damage to a painted surface;
1. remove any trace of oil and dirt using solvent wash;
2. remove all loose paint by chipping or scraping back until only sound paintwork
remains and clean the exposed surface by wire brushing or other mechanical means
to grade St2 of Swedish Standard SS 055900 (ISO 8501-1:1988);
3. sand down and feather a 25mm band of the sound bordering paintwork;
4. vacuum the surface to remove all dust and debris;
5. apply the paint system specified in Table 2.5.1-1.
To Next Page
Loading...
Need help?
General
