90
READY Mode
Setting the power system into READY
mode:
1 Ensure all unnecessary electrical loads
are switched off.
2 Ensure P or N is selected (If the shift
control knob is in any other position the
power system cannot be switched to the
ON/READY state)
3 Press brake pedal.
4 Press the START/STOP Switch (do not
hold the button in, release immediately)
IMPORTANT
• If the vehicle will not enter a READY state,
please check for any warning indicators
or messages displayed in the instrument
pack message centre. In extremely low
temperatures please allow 5 minutes
between power up attempts, if after 3
attempts the power state cannot be set to
READY please consult an MG Authorised
Repairer or breakdown service.
• Do not leave the power system in an
ACC or ON/READY state for long
periods of time, excessive use of electrical
equipment may lead to to a discharged
battery.
• The vehicle is fitted with an anti-theft
system. Independently sourced keys
may not allow vehicle entry and system
power up. Any new keys will require
programming using the manufacturers
software.
• Your car is fitted with complex
electronic control systems, please ensure
that all other radio transmission or
electromagnetic devices are kept away
from the smart key and centre console
cubby areas. They may cause interference
and operational issues. Please see the
‘Alternative Starting’ procedure.
Alternative Starting Procedure
If the vehicle is located in an area where there
are strong radio signals causing interference
or the smart key battery condition is low,
please use the following steps to attempt to
start the car:
1 Place the smart key centrally in the centre
console cup holder cubby box with the
buttons facing upward - as shown in the
illustration.
2 Ensure P or N is selected, press the
brake pedal and then press START/STOP
Switch to power the vehicle.
Starting & Driving
To Next Page
Loading...
