MG ZS EV - Rear Window Wiper Operation

27
Programmed Wash/Wipe
Pulling the lever toward the steering wheel
(6) will operate the windscreen washers.
After a short delay, the wipers will commence
operating in conjunction with the washers.
Note: The wipers continue operating
for a further three wipes after the lever
is released. After several seconds, there
willbeafurtherwipetoremoveanyuid
draining down the screen.
IMPORTANT
If the washers fail to deliver the screen
wash solution (dirt or ice may have
blocked the jets), release the lever
immediately. This will prevent the wipers
from operating, and the consequent risk
of visibility being impaired by dirt smearing
across the unwashed windscreen.
Rear Window Wiper Operation
The rear window wiper and washer will only
operate with the vehicle power system in
the ACC/ON/READY position. Operate the
lever to select different wipe speeds:
• Intermittent wipe (1)
• Wash and wipe (2)
• Wash and wipe (3)
• Intermittent wipe frequency adjustment
(4)
Intermittent Wipe
Turn the rear window wiper switch to
intermittent wipe (1), the rear window wiper
will operate, after 3 consecutive wipes, the
wipers will enter into intermittent mode.
The time period between the wipes can be
increased/decreased via the intermittent wipe
frequency adjustment switch (4).
Wash and Wipe
Turn the rear window wiper switch to wash
and wipe (2) position and hold, the rear
window wiper and washer will operate, the
rear window wiper wipes quickly. release the
switch allowing it to return to intermittent
wipe (1), the rear window washer will stop
operating.
Turn the rear window wiper switch to wash
and wipe (3) and hold, the rear window wiper
and washer will operate. release the switch
allowing it to return to OFF position, the rear
window washer will stop operating, and the
rear window wiper wipes for 3 times, after
several seconds, the wiper will wipe once
more to remove the washer fluid on the
windscreen.
Instruments and Controls
1