MG ZS EV - Switching the Power System off; Pedestrian Alert Control System

91
If the vehicle power system cannot be
changed after the car has left the area of
strong radio interference or had the smart
key battery replaced please consult an MG
Authorised Repairer.
IMPORTANT
The Alternative Starting Procedure should
only be required if the smart key battery is
very low or flat. Once the vehicle has been
removed from the area of excessive radio
interference the keyless entry and Start
Stop systems should return to normal.
Switching the Power System OFF
Setting the power system to OFF:
1 After bringing the car to a halt, ALWAYS
maintain brake pedal application.
2 Using the electronic shift control knob
select (P), this will automatically apply
the parking brake - please check that the
parking brake is applied.
3 Press START/STOP Switch to shut down
the power system.
Note: Please observe the park brake
warning light and message displayed
in the instrument pack message centre
conrming that the parking brake is
appliedbeforeexitingthevehicle.
Pedestrian Alert Control System
In order to improve the safety, your car is
fitted with a Pedestrian Alert System. When
the vehicle is travelling at a low speed, the
system controls a speaker that sounds to
remind pedestrians in the vicinity of your
presence.
Strategies of sounding warnings
The speaker sounds when all of the following
conditions are met:
1 The vehicle is READY;
2 The pedestrian alert system is fault free;
3 During acceleration, the vehicle speed
is less than 30km/h; during deceleration,
the vehicle speed is less than or equal to
25km/h.
Starting & Driving
4