MG ZS EV - Replacing the Battery

83
Replacing the Battery
Please use the picture guide to replace the
smart key battery if any of the following
conditions occur:
• The smart key locking/unlocking function
range is reduced;
• The message centre will display “Remote
Key Low Battery, Please Replace”.
1 Press the button (A) on the smart key to
eject the decorative trim.
2 Remove the backup mechanical key (B) in
the arrowed direction.
3 Using a suitable flat bladed tool, insert the
tool into the side of the key (C), carefully
prise off the battery cover and separate
the upper and lower casings (D).
4 Remove the battery from the slot.
5 Put the new battery in the slot, and make
sure it is in full contact with the slot.
Note: Make sure that the polarity of
batteryiscorrect(‘+’sidefacingdown).
Note:ItisrecommendedtouseaCR2032
battery.
6 Refit the cover and press tightly, ensuring
the gap around the cover is even.
7 Refit the mechanical key, and refit the
decorative trim.
8 Operate the vehicle power system to
resynchronize the key with the vehicle.
IMPORTANT
• Use of an incorrect or inappropriate
battery may damage the smart key.
The new replacement’s rated voltage,
sizes and specifications must be the
same as the old one.
• Incorrect fitting of the battery may
damage the key.
• Disposal of the used battery must be
strictly in accordance with relevant
environmental protection acts.
Starting & Driving
4