MG ZS EV - Switching the System Functions On;Off; System Functions

125
Note: The radar requires calibration
on new vehicles or for vehicles of where
a rear detecting radar sensor has been
replaced.Thereardetectionradarsensors
possessanautomaticcalibrationfunction
to compensate for installation error
within a certain range. When the vehicle
is running, the radar will automatically
enter the calibration state. During the
calibration process, the system will
provide limited functions, and the alarm
may be inaccurate. Upon completion of
the calibration, the system will resume all
functions.
Switching the System Functions On/Off
The rear driver assist system function and
sub system switches can be accessed via the
infotainment screen.
Select ON/OFF to activate/deactivate the
system.
System Functions
Note: The detection area, collision time
thresholdvalueandvehiclespeedprovided
inthesystemfunctiondescriptionarejust
for your reference.
Blind Spot Detection (BSD)
When the vehicle is driving forward, the
system will monitor the motor vehicles
located in the blind zones of the left and right
exterior mirrors. When the conditions for
activating the blind spot detection function are
met, the warning lamps in the corresponding
mirror will illuminate. Subsequent operation
of the relevant indicator will cause the
warning lamp in the mirror to flash to remind
the driver of an approaching vehicle.
Starting & Driving
4