155
Brake
DO NOT rest your foot on the
brake pedal while driving, which
may overheat the brake system,
thus reduce brake efciency and
cause excessive wear.
The free displacement of the brake pedal is
0~30 mm. Wear rates for brake pads and
discs may vary. The recommended minimum
thickness for brake pads is 2 mm, for front
brake discs is 23~25 mm and rear brake discs
is 8~10 mm.
For the first 1500 km, you should avoid
situations where heavy braking is required.
Please regularly check the wear condition of
all components of the brake system within
the time interval prescribed in Service
Portfolio and replace them if necessary to
ensure the long—term safety and optimum
performance .
The vehicle needs to run in for 800 km after
replacing brake pads or discs.
Brake Fluid Check and Top Up
Brake uid is highly toxic, keep
containers sealed and out of the
reach of children. If accidental
contactofbrakeuidissuspected,
seek medical attention immediately.
Prevent brake uid coming into
contact with the skin or eyes. If
this occurs, rinse immediately with
plenty of water. If eyes are still
red,painfuloruncomfortable,seek
medical attention immediately.
The brake fluid level should be checked
weekly when the system is cold and with the
vehicle on level ground.
The fluid level can be seen through the
reservoir and should be maintained between
‘MAX’ and ‘MIN’ mark.
Note:Donotallowtheuidleveltodrop
below ‘MIN’ mark or rise above ‘MAX’
mark.
Note: Brake uid will damage painted
surfaces. If you accidentally spill the
brake uid on the painted surface, soak
up any spillage with an absorbent cloth
immediately and wash the area with
waterorcarshampoo.
Brake Fluid Specification
Use the brake fluid recommended and
certified by the manufacturer. Refer to
‘Recommended Fluids and Capacities’ in
‘Technical Data’ chapter.
IMPORTANT
Replace brake fluid regularly according to
the Service Portfolio
Maintenance
6
To Next Page
Loading...
