MG ZS EV - Discharging

104
Discharging
The vehicle is equipped with a discharge
function, this can covert the high voltage DC
power in the high-voltage battery pack into
domestic AC power.
This discharge function can be realized by
using a discharge kit.
Note: Users have the opportunity to
purchase the discharge kit from an MG
AuthorisedRepairer.
To use the discharge function, follow the
instructions below:
1 Unlock the vehicle and access the AC
charging port (the charging port is also
the discharging port).
2 Insert the discharge gun connector into
the discharge port socket.
3 Access the discharger management
interface in the entertainment display
screen, ensure the cut-off power of
discharge is set. After setting, click the
start discharging button, the electronic
lock will lock the discharge gun in place
and the vehicle will enter the discharge
state. At this time, do not attempt to
remove the discharge gun using force,
this will damage the locking mechanism.
4 The user is able to click the stop
discharging button in the entertainment
display screen to stop the discharge, or
stop the discharge after the power is
discharged to the set cut-off value. At this
time the electronic lock will automatically
be released and the discharge gun can be
removed.
5 Make sure there is no debris or foreign
matter in the charging port, fit the
charging port cover and close the
charging point door.
Note: After the vehicle starts discharging,
iftheentertainmentdisplaygoesoff,the
vehicle will still maintain the discharging
condition.
Note:Duringdischarge,theSTART/STOP
switchcanbeplacedinthe“ON”position
to check the current power status and
driving range of the high-voltage battery
packviatheinstrumentcluster.
Note: During the discharge process, the
usercanstillsetthedischargepowercut-
offpoint.
Note: During discharge, the vehicle cannot
beplacedin“READY”mode.
Note: Using the discharge function will
reduce the driving range of the vehicle.
IMPORTANT
• Before beginning the discharge operation,
check the condition of the discharge
connector and gun.
• If it is necessary to use the discharge
function on wet days, please pay particular
attention in protecting the discharge port
area and discharge gun from water, rain
or snow.
• In cases of abnormal phenomena such
as peculiar smells, smoke emission or
overheating etc during the discharge
process, the electrical circuit MUST
be disconnected immediately and the
discharge operation stopped.
Starting & Driving