MG ZS EV - Vehicle Recovery

122
Parking Aid System
Ultrasonic Sensor Parking Aid
 The purpose of the parking aid
is to assist the driver in reversing!
The sensors may not be able to
detectobstaclesofcertaintype,e.g.
narrow posts or small objects no
more than a few inches wide, small
objectsclosetotheground,objects
abovethetailgateandsomeobjects
withnon-reectivesurfaces.
 Keep the sensors free from dirt,
ice and snow. If deposits build up
on the surface of the sensors, their
performance may be impaired.
When washing the car, avoid aiming
high pressurewaterjets directly at
the sensors from close range.
Rear Parking Aid
The ultrasonic sensors in the rear bumper
monitor the area behind the vehicle to search
for obstacles. If any obstacle is detected, the
system will calculate its distance from the
rear of the vehicle and communicates the
message to the driver by sounding warning
chimes.
Parking Aid in Operation
The rear parking aid is enabled automatically
when reverse is selected, it is switched off as
soon as reverse is disengaged. A short beep is
given by the parking aid within 1 second after
selecting reverse to indicate that the system
is operating normally.
The entertainment system screen will display
a silhouette image of the car showing the
object distance values for the sensor.
Note: If a longer, higher pitched sound
is emitted for 3 seconds when reverse
is selected this indicates a fault in the
system. In this case seek assistance from
yourMGAuthorisedRepairer.
With the parking aid enabled, when obstacles
are detected, the system will give sounds in
different frequencies (there might be blind
areas).
• If there is an obstacle within 1.2m range
from the rear sensors, the system starts
to emit a beeping sound. As the vehicle
moves closer to the obstacle, the beeps
are transmitted more rapidly.
• Once the obstruction is within 30cm
range of the rear bumper, the beeps will
merge into a continuous warning.
Starting & Driving