MG ZS EV - Page 138

126
The conditions for activating the blind spot
detection function include:
1 No faults are present in the system.
2 Blind spot detection (BSD) function is
enabled.
3 The vehicle speed is above 10mph
(15km/h).
4 There are motor vehicles in the blind
zone of the vehicle. The left and right
areas, which are 1m ahead and 7m
behind the rear of the vehicle, and 3.5m
to the side of the vehicle are the system
detection areas.
Note: The warning lamps will not
illuminate whilst you are overtaking
anothervehicleandyourspeedisgreater
thanthat ofthe vehicleyou arepassing,
even though it is in the blind zone.
Lane Change Assist (LCA)
When the vehicle is driving forward, the
system will monitor the motor vehicles
approaching rapidly in the adjacent lanes.
When the indicators are activated, and the
conditions for activating the lane change assist
function are met, the system will flash the
warning lamp within the respective mirror
to warn the driver of an approaching vehicle.
This aims to help avoid collisions when
changing lanes.
The conditions for activating the lane change
assist function include:
1 No faults are present in the system.
2 Lane change assist (LCA) function is
enabled.
3 The vehicle speed is above 10mph
(15km/h).
4 The speed of the approaching vehicle is
higher than the speed of your vehicle.
5 The approaching vehicle enters the
detection area of the lane change
assistance, the monitored areas are 7m -
70m behind your vehicle and 3.5m to the
side of your vehicle.
6 The approaching vehicle is likely to have
a collision with your vehicle within 3.5
seconds.
Starting & Driving