MG ZS EV - Page 112

100
Note: If at any time during the charging
process you should want to check the
state of charge, please switch the vehicle
power system to the ON position. The
high voltage battery state of charge will
be displayed in the message centre in
the instrument pack.
Residential Charging
During the charging operation the vehicle
power system must be OFF. Carry out the
following procedure to charge the vehicle:
1 Ensure the vehicle power system is OFF
and all doors are closed.
2 Open the charging port door, remove
the waterproof plug cover from the 7
pin charging plug connector. Ensure the
surroundings are clean, dry and free from
debris.
3 Connect the 7 pin charging plug to the
socket on the vehicle.
4 Connect the charging device plug to the
domestic electricity supply. Lock the
vehicle.
5 On completion of the charge, shut off the
power, unlock the vehicle, disconnect the
charging cable from the vehicle, and then
the domestic plug.
6 Ensure the charge socket is free from
debris, fit the waterproof plug cover.
Close the charging point door.
Note: If at any time during the charging
process you should want to check the
stateofcharge,pleaseswitchthevehicle
power system to the ON position. The
high voltage battery state of charge will
bedisplayedinthemessagecentreinthe
instrumentpack.
Starting & Driving