MG ZS EV - Tyre Pressure Monitoring System (TPMS)

116
When the Auto Hold is in the Parking
state, select D or R gear, press the
accelerator pedal, then the Auto Hold
will automatically exit the parking state
according to the gradient.
3 Off:
Press the Auto Hold switch again to turn
the function off.
In some circumstances such as releasing the
seat belt, switching off the power system,
remaining static for a length of time or
pressing the Auto Hold switch, it will result
in exiting the Auto Hold Parking state. At this
time the EPB will be applied.
Note:TheEPBwillNOTbeappliedwhen
pressingtheswitchtoturntheAutoHold
offwiththebrakepedalpressed.
Note: It is recommended to turn off the
Auto Hold function when reversing into
the garage.
Hill Hold Control (HHC)
 HHC has limitations when subject
to adverse conditions such as wet or
icysurfacesandsteepslopes.
DO NOT exit the vehicle with
only HHC applied, it may lead
to a serious accident when HHC
releases.
 Firm application of the brake
pedalwhenstoppingisrequiredby
HHC to generate sufcient brake
pressuretomaintainhold.
HHC assists the driver by ‘holding’ the vehicle
during hill starts. If the driver releases the
brake pedal, the HHC will hold the vehicle
stationary for a short time.
The following conditions must be fulfilled to
activate HHC:
• The driver’s door is closed and the driver
seat belt is fastened.
• The vehicle is stopped on a certain slope.
• SCS is fault free.
• EPB is fault free and released.
• START/STOP Switch is in READY state.
• D or R gear is selected.
• Sufficient brake pedal application force
has been applied.
Note: HHC is available in both forward
and backward directions when pulling
awayonuphillslopes.
Starting & Driving