59
Fastening Seat Belts
Please follow the instructions below to fasten
the seat belts correctly.
1 Adjust the seat correctly.
2 Hold the metal tab, pull the seat belt out
steadily over the shoulder and across
your chest. Ensure there is no twist on
the belt.
3 Insert the metal tab into the buckle until
you hear a ‘click’, this indicates the seat
belt is securely locked.
4 Remove any slackness in the belt by
pulling up on the diagonal section of the
belt.
5 To release the seat belt, press the red
button on the buckle. The seat belt will
retract automatically to its original place.
IMPORTANT
• Always ensure the seat belt will not
become trapped in the door aperture
when closing the door, damage will
occur.
• Pulling the seat belt out too quickly
may cause it to lock. In this case,
allow the seat belt to retract slightly
and then pull it across your body
slowly.
• If it is difficult to pull the seat belt out,
it may be due to twisted webbing. If
this is the case, fully extract the seat
belt, remove the twist, allow the seat
belt to retract slowly.
• When using the rear seat belts please
ensure they are fully retracted into
the correct position to avoid jamming
in the rear seat catches. Even if the
seat belt is twisted, it is still required
to be worn during driving, but the
twisted part of the seat belt should
not contact the passenger. When
this happens, please go to an MG
Authorised Repairer for repair.
Seats & Restraints
3
To Next Page
Loading...
