No TX if RX is active
TX if RX is active
Select if you want to prevent TX when RX is
currently active on the active frequency as
determined by your RX squelch setting.
TX Sidetone ON
TX Sidetone OFF
The TX sidetone is the sound routed to your
headsets when you are transmitting. The audio
signal here is derived from demodulating the
actual transmitter output signal. You can switch
this off. This may be desired for example if you are
using the V16 as base station and are using a
speaker. The speaker should be silent when you
are transmitting.
TX Power 5W
TX Power 10W
The V16 can be selected to use a lower TX power
for applications needing to reduce current
consumption during transmission or that may
suffer from RF feedback issues due to strong
transmissions in a compromised installation.
CAN Bus: COM1
CAN Bus: COM2
Note: This entry will only be shown in units where
addressable CAN bus is enabled at the factory.
Select here if the V16 should be addressed as
COM1 or COM2 if connected via the CAN bus.
Note: if you change this setting from a CAN bus
controller the communications will immediately
stop as the change takes effect immediately.
Also please make sure you only connect ONE V16
to the CAN bus at any one time. See notes below.
Intercom switch is mike
Intercom switch is playpack
Select if you would like to use the intercom switch
input as a microphone activation switch (this
option disables the VOX) or if you would like to
use this input as playback request for last RX.
Version Shows the firmware type and version
Serial Shows the serial number of the V16
Factory default Allows you to set all settings to factory default after
confirming the choice.
CAN bus addressing
The CAN bus can accept one or two V16 transceivers. These need to be identified as either
COM1 or COM2.
You perform this selection in the setup menu.
To Next Page
Loading...
